Hi Experts,
I have a SNP planning area, there are several key figure defined in planning area as reading from infocube (semantic 002). When I load data at material/location level, the data is loaded corrected from infocube. However, if I load 1 material at multiple location, the data could not be read from infocube. There is message at the bottom:
=================================
InfoCube not read. No characteristic or navigation attribute exists
Message no. /SAPAPO/TSM041
Diagnosis
To read an InfoCube, the system used a characteristic or navigation attribute
that is not contained in the InfoCube. Therefore, the InfoCube could not be
read.
Procedure
Either change the selection conditions or the characteristics to be displayed
(or the navigation attributes) in a way that allows the infoCube to be read, or
adapt the InfoCube.
A common cause is that the navigation attributes in the InfoCube to be read
have not been switched to an active state.
================================
Acording to the procedure mentioned above, i checked my selection condition. My selection is very simple, only contains the location and product. And my infocube is active, and have location, product as characteristic, and country and state as location's attribute.
Could anyone tell me how to make it work if loading multiple locations? We are using SCM release 713.
Thank you!
Anna